Effect of APB type on tensile properties of Cr added Fe3Al with D03 structure

K. Yoshimi, H. Terashima, S. Hanada

研究成果: ジャーナルへの寄稿学術論文査読

39 被引用数 (Scopus)

抄録

Fe25 mol.%Al2mol.%Cr, Fe28mol.%Al and Fe28mol.%Al2mol.%Cr alloys were prepared in order to investigate the effect of Cr addition on antiphase boundary (APB) types and tensile properties of D03 single-phase Fe3Al polycrystals. The highest elongation and the lowest work-hardening rate are obtained for Fe28Al2Cr. Fe25Al2Cr has the lowest elongation and the highest work-hardening rate. In addition to thermal APBs, many uncoupled superpartial dislocations dragging extended APBs can be seen in deformation microstructures for all the alloys. In Fe25Al2Cr B-type APBs are frequently observed with a small amount of D03-type APBs, whereas in Fe28Al and Fe28Al2Cr all of thermal or deformation-induced APBs are of D03-type. Uncoupled superpartial dislocations in deformed Fe25Al2Cr are blocked at thermal or deformation-induced APBs. By considering coordination configurations of neighbouring atoms at an APB, the blocking force against dislocation motions is shown to be higher for the B2-type APB than for the D03-type APB. This is related to the highest work-hardening rate of Fe25Al2Cr. In contrast, cross-slipping of uncoupled superpartials is more frequently observed in Fe28Al2Cr than in Fe28Al. The work-hardening rate of Fe28Al2Cr would be reduced by the occurrence of cross-slipping. Ductility improvement by the Cr addition is discussed in terms of an intrinsic change in the work-hardening rate of D03 Fe3Al alloys.

本文言語英語
ページ(範囲)53-61
ページ数9
ジャーナルMaterials Science and Engineering: A
194
1
DOI
出版ステータス出版済み - 1995 4月

フィンガープリント

「Effect of APB type on tensile properties of Cr added Fe3Al with D03 structure」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル